Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 852

5 SULB-1009 TABLE 7 Status messages and status codes (Continued) Status message "Remote CP is restoring its secondary partition." "Firmware download has started." "Firmware commit has started." "Firmware download has completed successfully." "Firmware commit has completed successfully." "Firmware commit has started to restore the secondary partition." "Firmware commit failed." "The secondary partition has been restored successfully." "Firmware is being downloaded to the blade. This step may take up to 10 minutes." "Firmware download timed out." "Reboot occurred during firmware download. Firmware commit will be started to recover the blade." "Blade rebooted during firmware commit. The operation will be restarted." "Firmware has been downloaded successfully. Blade is rebooting with the new firmware." "Blade has rebooted successfully." "New firmware failed to boot up. Run the firmwareDownload command again." "Firmware commit has started on the blade. This may take up to 10 minutes." "The firmwareRestore command is entered. System will reboot and a firmware commit operation will start upon bootup." "Switch is relocating the AP image." "The AP image is relocated successfully." "Switch reboots during relocating the AP image. The operation will be restarted." "Blade failed to reboot with the original image. The firmwareRestore command failed." Status code 0x8e 0x8f 0x90 0x91 0x92 0x93 0x94 0x95 0xa0 0xa1 0xa2 0xa3 0xa4 0xa5 0xa6 0xa7 0xa8 0xa9 0xaa 0xab 0xac The following table lists additional firmwareDownload error messages and error codes. The error code provide more details on the reason for firmware download failure. TABLE 8 Error messages and error codes Error message Error code "Image is up-to-date. No need to download the same version of firmware." 0xF "Upgrade is inconsistent." 0x10 "OSRootPartition is inconsistent. For example: swap OSRootPartitions and reboot." 0x11 "Unable to access the required package list file. Check whether the switch is supported by the requested firmware. Also check the firmwareDownload help page for other possible failure reasons." 0x12 "The RPM package database is inconsistent. Contact your switch service provider for 0x13 recovery." 830 Fabric OS Message Reference 53-1002749-01