Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 39

Displaying system message logs and attributes 1 Enabling a RASLog message or module To enable a single RASLog message or all messages in a module that were previously disabled, perform the following steps. 1. Log in to the switch as admin. 2. Use the following commands to enable a single RASLog message or all messages that belong to a module: • Execute the rasadmin --enable -log messgae_ID command to enable a single RASLog message that has been disabled. For example, execute the following command to enable BL-1001 message that was previously disabled. switch:admin> rasadmin --enable -log BL-1001 2012/10/15-13:24:30, [LOG-1006], 373, SLOT 4 | CHASSIS, INFO, switch, Log message BL-1001 has been enabled. Use the rasadmin --show -log messgae_ID command to verify the status of the message. • Execute the rasadmin --enable -module module_ID command to enable all messages in a module. For example, execute the following command to enable to all previously disabled BL messages. switch:admin> rasadmin --enable -module BL 2012/10/15-13:28:37, [LOG-1007], 375, SLOT 4 | CHASSIS, INFO, switch, Log Module BL has been enabled. Use the rasadmin --show -module module_ID command to verify the status of the messages that belong to a module. Setting the severity level of a RASLog message To change the default severity level of a RASLog message, perform the following steps. 1. Log in to the switch as admin. 2. Use the rasadmin --set -log message_ID -severity [DEFAULT | INFO | WARNING | ERROR | CRITICAL] to change the severity level of a message. For example, execute the following command to change the severity level of C2-1004 message to WARNING. switch:admin> rasadmin --set -log C2-1004 -severity WARNING 3. Use the rasadmin --show -severity message_ID command to verify the severity of the message. switch:admin> rasadmin --show -severity C2-1004 Message Severity C2-1004 : WARNING Displaying system message logs and attributes This section provides information on displaying the system message logs. These procedures are valid for all the supported platforms. Fabric OS Message Reference 17 53-1002749-01