Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 388

5 FCR-1075 FCR-1075 Message Zone Name configuration is larger than characters in the edge fabric connected to port . Message Type LOG Severity ERROR Probable Cause Indicates that the zone name configuration size created in the connected fabric exceeds the maximum supported by the FC Router. This size is equal to the total number of characters used by all the zone names in the edge fabric zoning database. The limit includes both LSAN and non-LSAN zone names defined in the zoning name database of the edge fabric. Recommended Action Limit the zone configuration size in the edge fabric connected to this port by either reducing the number of zones or changing the zone names to smaller names. FCR-1076 Message Port disabled, system only supports front domains. Message Type LOG Severity INFO Probable Cause Indicates that the maximum number of supported front domains was exceeded. To enable the specified port, disable any other operational front domain and then re-enable the port. Recommended Action Make sure to remain within the maximum number of supported front domains. FCR-1077 Message Port rejected fabric binding request/check from the M-Model switch; . Message Type LOG Severity WARNING Probable Cause Indicates that an M-Model edge switch attempted to either activate or check the fabric binding. This port will be disabled if this event occurred during a check of fabric binding and not during failure to activate fabric binding. The error is caused when the binding list details configured on the M-Model switch do not match with the currently configured front port domain ID and WWN of the EX_Port on which this operation was attempted. Recommended Action Ensure that the M-Model switch has the same currently configured details such as the front port domain ID and WWN of the EX_Port on which this operation was attempted. 366 Fabric OS Message Reference 53-1002749-01