Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 341

FABR-1051 5 FABR-1051 Message D-Port test failed for slot and port . Message Type LOG Severity ERROR Probable Cause Indicates that the D_Port test failed for the given slot and port due to one of the following reasons: • The small form-factor pluggable (SFP) fault detected by electrical loopback test failure. • The cable fault detected by optical loopback test failure. • An application-specific integrated circuit (ASIC) issue detected by link traffic test failure. Recommended Action Replace the faulty SFPs, cables, or blade. FABR-1052 Message The configured port speed (16G/10G on non FC16 blade or 1G on FC16 blade) is invalid. Persistently disabling port . Message Type LOG Severity INFO Probable Cause Indicates that the configured speed (16 Gbps or 10 Gbps on the non-FC16 blade or 1 Gbps on the FC16 blade) for the specified port is invalid. Recommended Action Execute the portCfgSpeed command to change the port speed. FABR-1053 Message The switch is disabled due to an inconsistency found in the interop config parameters. Message Type LOG Severity CRITICAL Probable Cause Indicates that the configuration keys have interopmode parameters such as switch.interopMode and switch.mcdtFabricmode set. Recommended Action Execute the interopmode command to reset the parameters. Fabric OS Message Reference 319 53-1002749-01