Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 36

1 Displaying message content on switch TABLE 3 Commands for viewing or configuring the system parameters and message logs (Continued) Command Description portLogResize portLogShow portLogShowPort portLogTypeDisable portLogTypeEnable rasAdmin rasMan setVerbose Resizes the port log to the specified number of entries. Displays the port log, with page breaks. Displays the port log of the specified port, with page breaks. Disables an event from reporting to the port log. Port log events are described by the portLogEventShow command. Enables an event to report to the port log. Port log events are described by the portLogEventShow command. Used to enable or disable logging for selected messages or modules, to change the default severity level for a specified message, and to display configured RASLog message settings. Displays message documentation on switch. Sets the verbose level of a particular module within the Fabric OS. snmpConfig Manages the SNMP agent configuration. supportFfdc Enables and disables FFDC. supportFtp supportSave supportShow Sets, clears, or displays support FTP parameters or a time interval to check the FTP server. Collects RASLog, trace files, and supportShow (active CP only) information for the local CP and then transfers the files to an FTP server. The operation can take several minutes. Executes a list of diagnostic and error display commands. This output is used by your switch service provider to diagnose and correct problems with the switch. The output from this command is very long. syslogdFacility Changes the syslogd facility. syslogdIpAdd Adds an IP address as a recipient of system messages. syslogdIpRemove Removes an IP address as a recipient of system messages. syslogdIpShow Views the currently configured IP addresses that are recipients of system messages. traceDump Displays, initiates, or removes a Fabric OS module trace dump. Displaying message content on switch Beginning with Fabric OS v7.1.0, you can view the message documentation such as the message text, message type, class (for audit messages), message severity, cause, and action on the switch console by using the rasMan message_ID command. To display the message documentation on switch, perform the following steps. 1. Log in to the switch as admin. 2. Use the rasMan message_ID command to display the documentation of a message. The message_ID values are case-sensitive. 14 Fabric OS Message Reference 53-1002749-01