Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 365

FCPH-1001 5 FCPH Messages FCPH-1001 Message : failed, out of memory condition. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the switch is low on memory and failed to allocate new memory for a Fibre Channel driver instance. The function value can only be fc_create. This function creates a Fibre Channel driver instance. The failed function call can only be kmalloc_wrapper, which has failed. This function call is for kernel memory allocation. Recommended Action A non-bladed switch will automatically reboot. For a bladed switch, the active CP blade will automatically fail over and the standby CP will become the active CP. FCPH-1002 Message Port has been disabled since switch requires authentication when device authentication policy is set to ON. Message Type LOG Severity WARNING Probable Cause Indicates a device that does not support authentication has tried to log in to the switch when the device authentication policy is in ON status on the switch. Recommended Action Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on the switch if it is not mandatory. Use the authUtil command to change the device authentication policy. FCPH-1003 Message New port has same Port WWN as old port as part of duplicate Port WWN detection policy. Message Type LOG Severity WARNING Probable Cause Indicates that the specified new port has the same Port World Wide Name (PWWN) as the old port. Recommended Action No action is required. Fabric OS Message Reference 343 53-1002749-01