Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 381

FCR-1054 5 FCR-1054 Message Port received ILS of incorrect size (); valid ILS size is . Message Type LOG Severity WARNING Probable Cause Indicates that an internal link service (ILS) IU of invalid size was received from the switch on the other end of the link. Recommended Action Check the error message log on the other switch using the errShow command for additional messages. Check for a faulty cable or deteriorated small form-factor pluggable (SFP). Replace the cable or the SFP if necessary. Run the portLogDumpPort command on both the receiving and transmitting ports. Run the fabStatsShow command on the transmitting switch. If the message persists, collect switch information using the supportSave command, and contact your switch service provider. FCR-1055 Message Switch with domain ID does not support backbone to edge imports. Message Type LOG Severity INFO Probable Cause Indicates that a switch that does not support backbone-to-edge routing was detected in the backbone. Edge-to-edge routing will work, but backbone-to-edge routing may fail. Recommended Action No action is required if backbone-to-edge routing is not required. Otherwise, replace the switch with one that supports backbone-to-edge routing. FCR-1056 Message Switch with front domain ID does not support backbone to edge imports. Message Type LOG Severity INFO Probable Cause Indicates that a switch that does not support backbone-to-edge routing is running in the MetaSAN. Recommended Action No action is required if backbone-to-edge routing is not needed. Otherwise, replace the switch with one that supports backbone-to-edge routing. Fabric OS Message Reference 359 53-1002749-01