Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 188

5 BL-1010 Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1010 Message Blade in slot inconsistent with the hardware settings. Message Type LOG Severity WARNING Probable Cause Indicates that a failover occurred while some hardware changes (such as changing the domain ID) were being made on the previously active control processor (CP). Recommended Action No action is required. This blade has been reinitialized. Because reinitializing a blade is a disruptive operation and can stop I/O traffic, you may need to stop and restart the traffic during this process. BL-1011 Message Busy with emb-port int. for chip in minis on blade , chip int. is disabled. interrupt status=0x. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that too many interrupts in the embedded port caused the specified chip to be disabled. The probable cause is too many abnormal frames; the chip is disabled to prevent the control processor (CP) from becoming too busy. Recommended Action Make sure to capture the console output during this process. Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the specified port. On a bladed switch, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. On a non-bladed switch, reboot or power cycle the switch. If the message persists, replace the blade or the (non-bladed) switch. 166 Fabric OS Message Reference 53-1002749-01