Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 771

SEC-1330 5 SEC-1330 Message command failed - db(s) are coming from a non-Primary switch. Message Type LOG Severity ERROR Probable Cause Indicates an attempt was made to distribute databases either from a backup fabric configuration server (FCS) switch or a non-FCS switch. Recommended Action Verify the distribution is initiated by the FCS switch. Use the secPolicyShow command to verify and correct the configuration if necessary. SEC-1331 Message Attempt to enable secure mode failed. Reason: . Message Type LOG Severity ERROR Probable Cause Indicates the secModeEnable command failed on the fabric because default IP filter policies are not active on the switch, or an active transaction exists on IP filter policies. Recommended Action Verify the security event was planned. If the security event was planned, run the ipfilter --activate default_ipv4 command or the ipfilter --activate default_ipv6 command to activate default IP filter policies. Use the ipfilter --save or ipfilter --transabort commands to save or abort the active transaction on IP filter policies. Then retry the secModeEnable command. SEC-1332 Message Fabric wide policy is conflicting as is present in the fabric wide policy and 5.3 or 5.2 switches present in the fabric. Message Type LOG Severity ERROR Probable Cause Indicates the fabric-wide policy is conflicting. Recommended Action Remove either the FCS from the fabric-wide policy, or remove Fabric OS v5.3 or Fabric OS v5.2 switches from the fabric, or set the fabric-wide mode for FCS as strict. Fabric OS Message Reference 749 53-1002749-01