Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 746

5 SEC-1154 SEC-1154 Message PID change failed: . Message Type LOG Severity INFO Probable Cause Indicates that either the defined or the active policy could not be updated. If the policy database is very large, it might not be able to change the index/area because the new policy database exceeds the maximum size. This message can also be caused when the switch is short of memory. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Action Reduce the size of the policy database. SEC-1155 Message PID change failed: . Message Type LOG Severity INFO Probable Cause Indicates that either the defined or active policy was too large after modifying the index/area ID. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Action Reduce the size of the specified policy database. SEC-1156 Message Change failed: . Message Type LOG Severity INFO Probable Cause Indicates the security daemon is busy. The status values can be defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Action For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands may take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes between executing commands so that your commands do not overlap in the fabric. 724 Fabric OS Message Reference 53-1002749-01