Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 543

FW-1435 5 FW-1435 Message Switch status change contributing factor Flash: usage out of range. Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the flash memory usage is out of range. The policy was set using the switchStatusPolicySet command. Recommended Action Execute the supportSave command to clear out the kernel flash. FW-1436 Message Switch status change contributing factor Marginal ports: marginal out of ports:config( percent,). (Port(s) ). Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command. A port is faulty when the port value is Link Loss, Synchronization Loss, Signal Loss, Invalid word, Protocol error, CRC error, Port state change, or Buffer Limited Port is above the high boundary. Recommended Action Replace the faulty or deteriorating small form-factor pluggable (SFP). Execute the fwportdetailshow command to know the reason for marginal ports. FW-1437 Message Switch status change contributing factor Faulty ports: faulty out of ports:config( percent,). (Port(s) ). Message Type LOG Severity WARNING Probable Cause Indicates that the switch is not in a healthy state. This occurred because the number of faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or port. Recommended Action Replace any faulty or deteriorating SFPs. Fabric OS Message Reference 521 53-1002749-01