Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 642

5 MS-1009 MS-1009 Message RLIR event. Slot/Port / (0x). Device Port Tag is 0x. . Message Type LOG Severity ERROR Probable Cause Indicates a registered link incident record (RLIR) has been generated for one of the actions indicated by the message value. The message value can be one of the following: • Exceeded bit error rate threshold • Loss of signal or synchronization • Not operational seq recognized • Primitive sequence timeout • Unrecognized link incident Recommended Action Persistent RLIR incidents are likely the result of SAN hardware problems such as bad cables or small form-factor pluggable (SFP) transceivers. If the message persists, replace hardware. MS-1021 Message MS WARMBOOT failure(FSS_MS_WARMINIT failed. Reason=). Message Type LOG Severity ERROR Probable Cause Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during the WARM INIT phase of a reboot. Recommended Action If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. MS-1022 Message Management Server Platform Service . Message Type LOG Severity INFO Probable Cause Indicates that the Management Server (MS) platform service is being activated or deactivated. Recommended Action No action is required. 620 Fabric OS Message Reference 53-1002749-01