Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 743

SEC-1135 5 Recommended Action Verify the security event was planned. If the security event was planned, no action is required. If the security event was not planned, take appropriate action as defined by your enterprise security policy. SEC-1135 Message Secure fabric version stamp has been reset. Message Type LOG Severity INFO Probable Cause Indicates the version stamp of the secure fabric is reset. Recommended Action Verify the security event was planned. If the security event was planned, no action is required. If the security event was not planned, take appropriate action as defined by your enterprise security policy. SEC-1136 Message Failed to verify signature . Message Type LOG Severity ERROR Probable Cause Indicates the receiving switch failed to validate the security database sent from the primary fabric configuration server (FCS) switch. This message usually indicates that the data package is corrupted, the time stamp on the package is out of range as a result of a replay attack or out-of-sync time service, or the signature verification failed. Signature verification failure indicates either an internal error (such as losing the primary public key) or an invalid database. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that switch. This message may also be the result of an internal corruption or a hacker attack to the secure fabric. SEC-1137 Message No signature in . Message Type LOG Severity ERROR Probable Cause Indicates the receiving switch failed to validate the security database sent from the primary fabric configuration server (FCS) switch. This message usually indicates that the data package is corrupted, the time stamp on the package is out of range as a result of a replay attack or out-of-sync time service, or the signature verification failed. Signature verification failure indicates either an internal error (such as losing the primary public key) or an invalid database. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that switch. This message may also be the result of an internal corruption or a hacker attack to the secure fabric. Fabric OS Message Reference 721 53-1002749-01