Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 187

BL-1007 5 BL-1007 Message blade #: blade state is inconsistent with EM. bl_cflags 0x, slot_on , slot_off , faulty , status . Message Type LOG Severity WARNING Probable Cause Indicates that a failover occurred while a blade was initializing on the previously active control processor (CP). Recommended Action No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation and can stop I/O traffic, you may need to stop and restart the traffic during this process. BL-1008 Message Slot control-plane failure. Expected value: 0x, Actual: 0x. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the blade has experienced a hardware failure or was removed without following the recommended removal procedure. Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. If the message persists, replace the blade. BL-1009 Message Blade in slot timed out initializing the chips. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the blade has failed to initialize the application-specific integrated circuit (ASIC) chips. Fabric OS Message Reference 165 53-1002749-01