Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 394

5 FCR-1094 FCR-1094 Message No Integrated Routing license present. EX-Port will not perform device sharing with other Brocade Native mode fabric(s). Message Type LOG Severity WARNING Probable Cause Indicates that an EX_Port has been configured in Brocade Native mode. Device sharing will not occur with other Brocade Native mode fabrics because the Integrated Routing license is not installed. Recommended Action Install Integrated Routing license if device sharing is needed with other Brocade Native mode fabrics. FCR-1095 Message The EX-Port is configured in 'McData/Open' Mode which is no longer supported, hence will be disabled next time port is offline and online. Message Type LOG Severity WARNING Probable Cause Indicates that an EX_Port has been configured in 'McData/Open' mode. Initially after HA failover, the EX_Port will come up in McDATA mode. Further toggling will disable the port. Recommended Action Remove the 'McData/Open' interop modes in all EX_Ports FCR-1096 Message Failed to allocate for : port . Message Type LOG Severity ERROR Probable Cause Indicates that the authentication process failed because the system is low on memory. Data type is the payload or structure that failed to get memory. Operation phase specifies which operation of a particular authentication phase failed. Recommended Action Usually this problem is transient. The authentication may fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. 372 Fabric OS Message Reference 53-1002749-01