Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 171

AUTH-1018 5 AUTH-1018 Message Invalid value to check protocol type: port . Message Type LOG Severity ERROR Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1020 Message Failed to create timer for authentication: port . Message Type LOG Severity INFO Probable Cause Indicates that an authentication message timer was not created. Usually this problem is transient. The authentication may fail. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1022 Message Failed to extract from payload: port . Message Type LOG Severity ERROR Probable Cause Indicates the authentication process failed to extract a particular value from the receiving payload. Usually this problem is transient. The authentication may fail. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. Fabric OS Message Reference 149 53-1002749-01