Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 882

5 TRCE-1007 TRCE-1007 Message Notification of this CP has failed. Parameters temporarily out of synch with other CP. Message Type LOG Severity INFO Probable Cause Indicates that the active control processor (CP) is unable to alert the standby CP of a change in trace status. This message is only applicable to bladed switches. Recommended Action This message is often transitory. Wait a few minutes and try the command again. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. TRCE-1008 Message Unable to load trace parameters. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the active control processor (CP) is unable to read the stored trace parameters. Recommended Action Reboot the CP (dual-CP system) or restart the switch. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. TRCE-1009 Message Unable to alert active CP that a dump has occurred. Message Type LOG Severity WARNING Probable Cause Indicates that the standby control processor (CP) is unable to communicate trace information to active CP. This message is only applicable to bladed switches. Recommended Action Execute the haShow command to verify that the current CP is standby and the other CP is active. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. 860 Fabric OS Message Reference 53-1002749-01