Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 307

EM-1031 5 Recommended Action This is often a transient error. Watch for the EM-1048 message, which indicates that the problem has been resolved. If the problem persists, check for loose or dirty connections. Remove all dust and debris before reseating the field-replaceable unit (FRU). If it continues to fail, replace the FRU. EM-1031 Message ejector not closed. Message Type LOG Severity ERROR Probable Cause Indicates that the environmental monitor (EM) has found a switch blade that is inserted, but at least one ejector switch is not latched. The blade in the specified slot is treated as not inserted. Recommended Action Close the ejector switch (raise the slider in most blades or completely screw in the upper thumbscrew) if the field-replaceable unit (FRU) is intended for use. Refer to the appropriate Hardware Reference Manual for instructions on inserting the switch blades. EM-1033 Message CP in set to faulty because CP ERROR asserted. Message Type LOG Severity ERROR Probable Cause Indicates that the standby control processor (CP) has been detected as faulty. The high availability (HA) feature will not be available. This message occurs every time the other CP restarts, even as part of a clean warm failover. In most situations, this message is followed by the EM-1047 message, and no action is required for the standby CP; however, find the reason for failover. Recommended Action If the standby CP was restarted, wait for the error to clear (execute the slotShow command to determine if it has cleared). Watch for the EM-1047 message to verify that this error has cleared. If the standby CP continues to be faulty or if it was not intentionally restarted, check the error logs on the other CP (using the errDump command) to determine the cause of the error state. Reseat the field-replaceable unit (FRU). If the problem persists, replace the FRU. EM-1034 Message set to faulty, rc=. Message Type LOG Severity ERROR Probable Cause Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified reason. Fabric OS Message Reference 285 53-1002749-01