Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 204

5 BM-1001 BM Messages BM-1001 Message BM protocol version in slot . Message Type LOG Severity ERROR Probable Cause Indicates that the firmware running on the control processor (CP) cannot communicate with the application processor (AP) blade in the indicated slot and determine the AP blade's firmware version. The reason can be one of the following: • The CP blade is running a later version of firmware than the AP blade. • The CP blade is running an earlier version of firmware than the AP blade. Recommended Action The problem can be corrected by changing the firmware version on either the CP or on the AP blade. You can modify the firmware version on the CP blade by using the firmwareDownload command. Refer to the release notes to determine whether a non-disruptive firmware download is supported between the revisions. Because the AP and CP blades cannot communicate, it is not possible to load new firmware on the AP blade. If necessary, send the AP blade back to the factory for a firmware update. BM-1002 Message Connection established between CP and blade in slot . Message Type LOG Severity INFO Probable Cause Indicates that the control processor (CP) has established a connection to the blade processor (BP) and can communicate. Recommended Action No action is required. BM-1003 Message Failed to establish connection between CP and blade in slot . Faulting blade. Message Type LOG | FFDC Severity WARNING Probable Cause Indicates that the control processor (CP) could not establish a connection to the blade processor (BP) to communicate. 182 Fabric OS Message Reference 53-1002749-01