Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 872

5 SWCH-1022 SWCH-1022 Message Port: has been disabled due to port address conflict while enabling FMS mode. Message Type LOG Severity WARNING Probable Cause Indicates that the switch has ports with FICON Management Server (FMS) reserved areas (0xFE, 0xFF) that are not supported in FMS mode. Recommended Action No action required. Refer to the FICON Administrator's Guide for more information. SWCH-1023 Message HA state out of sync: Standby CP (ver = ) does not support XISL use while fmsmode and/or lossless are enabled (Active CP version =). Message Type LOG Severity WARNING Probable Cause Indicates that the standby control processor (CP) does not support extended inter-switch link (XISL) while FICON Management Server (FMS) mode and Lossless are enabled. Recommended Action Load a firmware version on standby CP that supports both XISL use and FMS mode and Lossless at the same time by using the firmwareDownload command. SWCH-1024 Message HA state out of sync: Standby CP (ver = ) does not support active's enforce_login policy (Active CP version =). Message Type LOG Severity WARNING Probable Cause Indicates that the standby control processor (CP) does not enforce login policy of the active CP. Recommended Action Configure the enforce login policy to a value that the standby CP supports. 850 Fabric OS Message Reference 53-1002749-01