Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 175

AUTH-1032 5 Recommended Action Reset the secret value using the secAuthSecret command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1032 Message Failed to generate for payload: length , error code , port . Message Type LOG Severity ERROR Probable Cause Indicates that the authentication process failed to generate specific data (challenge, nonce, or response data) for an authentication payload. This usually relates to internal failure. A nonce is a single-use, usually random value used in authentication protocols to prevent replay attacks. Usually this problem is transient. The authentication may fail. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1033 Message Disable port due to unauthorized switch . Message Type LOG Severity ERROR Probable Cause Indicates that an entity was not configured in the Switch Connection Control (SCC) policy and tried to connect to the port. Recommended Action Add World Wide Name (WWN) of the entity to the SCC policy and reinitialize authentication by using the portDisable and portEnable commands or the switchDisable and switchEnable commands. AUTH-1034 Message Failed to validate name in : port . Message Type LOG Severity ERROR Probable Cause Indicates that the specified entity name in the payload is not in the correct format. Fabric OS Message Reference 153 53-1002749-01