Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 301

EM-1004 5 EM-1004 Message failed to power on. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the specified field-replaceable unit (FRU) failed to power on and is not being used. The FRU ID value is composed of a FRU type string and an optional number to identify the unit, slot, or port. The Brocade 300 switch has 4 fans and 1 power supply, but these parts cannot be replaced: the entire switch is a FRU. Recommended Action Reseat the FRU. If the problem persists, replace the FRU. EM-1005 Message has faulted. Sensor(s) above maximum limits. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that a blade in the specified slot or the switch (for non-bladed switches) is shutdown for environmental reasons; its temperature or voltage is out of range. Recommended Action Check the environment and make sure the room temperature is within the operational range of the switch. Execute the fanShow command to verify fans are operating properly. Make sure there are no blockages of the airflow around the chassis. If the temperature problem is isolated to the blade itself, replace the blade. Voltage problems on a blade are likely a hardware problem on the blade itself; replace the blade. EM-1006 Message has faulted. Sensor(s) below minimum limits. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the voltage on a switch is below minimum limits. The switch or specified blade is being shutdown for environmental reasons; the voltage is too low. Recommended Action If this problem occurs on a blade, it usually indicates a hardware problem on the blade; replace the blade. If this problem occurs on a switch, it usually indicates a hardware problem on the main board; replace the switch. Fabric OS Message Reference 279 53-1002749-01