Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 737

SEC-1106 5 SEC-1106 Message Failed to sign message data. Message Type LOG Severity ERROR Probable Cause Indicates that some public key infrastructure (PKI) objects on the switch are not in a valid state, and a signature operation failed. Recommended Action Run the secCertUtil show -fcapall command and verify that all PKI objects exist on the switch. If a failure to validate PKI objects occurs, follow the steps for re-creating PKI objects outlined in the Fabric OS Administrator's Guide. SEC-1107 Message Stamp is 0. Message Type LOG Severity INFO Probable Cause Indicates a corruption occurred during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) distributes the security database to the other switches in the fabric, and then local validation finds the error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that specific switch. SEC-1108 Message Fail to reset stamp on all switches. Message Type LOG Severity ERROR Probable Cause Indicates that a version reset operation failed either because the switch could not get all the required resources to perform the operation or because it failed to send the message to all switches in the fabric. Recommended Action Verify that the security event was planned. If the security event was planned, run the secFabricShow command to verify that all switches in the fabric are in the ready state. When all switches are in the ready state, retry the operation. Fabric OS Message Reference 715 53-1002749-01