Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 727

SEC-1075 5 SEC-1075 Message Fail to new policy set on all switches. Message Type LOG Severity ERROR Probable Cause Indicates a corruption occurred during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) distributes the security database to the other switches in the fabric, and then local validation finds the error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database may not be correctly updated for that specific switch. SEC-1076 Message NoNodeWWNZoning option has been changed. Message Type LOG Severity ERROR Probable Cause Indicates the NoNodeWWNZoning option has been changed. If the option is turned on, a zone member can be added using node WWNs, but the member will not be able to communicate with others nodes in the zone. Recommended Action Re-enable the current zone configuration for the change to take effect. SEC-1077 Message Failed to activate new policy set on all switches. Message Type LOG Severity ERROR Probable Cause Indicates the policy could not be activated. Possible reasons that the policy could not be activated include not enough memory or a busy switch. Recommended Action Run the secFabricShow command to verify that all switches in the fabric are in the ready state. Retry the command when all switches are ready. Fabric OS Message Reference 705 53-1002749-01