Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 857

SULB-1020 5 SULB-1020 Message New firmware failed to boot in slot . Message Type AUDIT | LOG Class FIRMWARE Severity ERROR Probable Cause Indicates that the BP blade is still running the old image even though it should reboot with the new image. This error may indicate that the new image has not been loaded correctly to the specified blade. Recommended Action Run the slotShow command. If the blade is in a FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmware download to the blade. If the blade is stuck in LOADING state, remove and re-insert the blade to trigger another firmware download. If the problem persists, contact your switch service provider. SULB-1021 Message Firmware is being downloaded to the blade in slot . Message Type AUDIT | LOG Class FIRMWARE Severity WARNING Probable Cause Indicates that the firmware is being loaded to the specified blade. Recommended Action Run the firmwareDownloadStatus command to monitor the firmware download progress. After it finishes, run the firmwareShow command to verify the firmware versions. SULB-1022 Message The blade in slot has rebooted successfully with new firmware. Message Type LOG Severity WARNING Probable Cause Indicates that the blade in the specified slot has rebooted with new firmware. This is a normal step in the firmware download process. Recommended Action Run the firmwareDownloadStatus command to monitor the firmware download progress. Fabric OS Message Reference 835 53-1002749-01