Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 179

AUTH-1043 5 Recommended Action Check the connection port for a possible security attack. Check the shared secrets using the secAuthSecret command and reinitialize authentication using the portDisable and portEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1043 Message Failed to enforce device authentication mode:(error: ). Message Type LOG Severity ERROR Probable Cause Indicates that the Kernel mode setting for F_Port authentication failed. Device authentication will be defaulted to OFF, and the switch will not participate in Diffie Hellman - Challenge Handshake Authentication Protocol (DH-CHAP) authentication with other devices. Recommended Action Set the device authentication policy manually using the authUtil command. AUTH-1044 Message Authentication . Disabling the port . Message Type LOG | FFDC Severity ERROR Probable Cause Indicates that authentication has timed out after multiple retries. The specified port has been disabled as a result. This problem may be transient due to the system CPU load. In addition, a defective small form-factor pluggable (SFP) transceiver or faulty cable may have caused the failure. Recommended Action Check the SFP transceiver and the cable; then enable the port using the portEnable command. AUTH-1045 Message Certificate not present in this switch in port . Message Type AUDIT | LOG Class SECURITY Severity ERROR Probable Cause Indicates that the public key infrastructure (PKI) certificate is not installed in this switch. Fabric OS Message Reference 157 53-1002749-01