Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 338

5 FABR-1041 FABR-1041 Message Port is disabled due to trunk protocol error. Message Type LOG Severity ERROR Probable Cause Indicates a link reset was received before the completion of the trunking protocol on the port. Recommended Action Enable the port by running the portEnable command. The port may recover by re-initialization of the link. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. FABR-1043 Message Detected Fabric ID conflict with remote (not neighbor) switch (domain ), FID . No local E_Ports disabled. Message Type LOG Severity ERROR Probable Cause Indicates that the remote switch has a Fabric ID (FID) conflict with the local switch. But no ports are disabled because the remote switch is not an adjacent to the local switch. Recommended Action Make sure that all the switches in the fabric have the same FID or upgrade the switch firmware to a VF-capable firmware. FABR-1044 Message Detected Fabric ID conflict with neighbor switch (domain ), FID . E_Ports () connected to the switch are disabled. Message Type LOG Severity ERROR Probable Cause Indicates that the neighbor switch has a Fabric ID (FID) conflict with the local switch. All E_Ports directly connected to the conflicting switch are disabled. Recommended Action Make sure that all the switches in the fabric have the same FID or upgrade the switch firmware to a VF-capable firmware. 316 Fabric OS Message Reference 53-1002749-01