Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 383

FCR-1060 5 FCR-1060 Message EX_Port() has an incompatible configuration setting. Message Type LOG Severity WARNING Probable Cause Indicates that virtual channel (VC) Link Init is enabled on the local switch and the remote switch is negotiating in R_RDY mode. The fabric might not form properly. Recommended Action Check the configuration on the local switch using the portCfgShow command to verify that the VC Link Init is disabled, if the remote switch is configured in R_RDY mode or only capable of R_RDY mode. • VC_RDY mode: Virtual channel flow control mode. This is a proprietary protocol. • R_RDY mode: Receiver-ready flow control mode. This is the Fibre Channel standard protocol, that uses R_RDY primitive for flow control. FCR-1061 Message Backbone fabric created on port . Message Type LOG Severity INFO Probable Cause Indicates that a backbone fabric was built on the specified port. Recommended Action No action is required. FCR-1062 Message Port disabled, system only supports EX/VEX_ports. Message Type LOG Severity INFO Probable Cause Indicates that the maximum number of supported EX_Ports or VEX_Ports was exceeded. To enable the specified port, disable any other operational port and then re-enable the port. Recommended Action No action is required. Fabric OS Message Reference 361 53-1002749-01