Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 874

5 SYSC-1001 SYSC Messages SYSC-1001 Message Failed to run :. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that one of the programs would not run on the system during the boot sequence. Recommended Action If the message is reported during a reboot after new firmware has been loaded, try reloading the firmware using the firmwareDownload command. If the message persists, there may be a conflict between the two versions of firmware or the nonvolatile storage may be corrupted. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. SYSC-1002 Message Switch bring-up timed out. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that the system timed out during a reboot or failover sequence, waiting for one or more programs to register with system services or to fail over to active status. Recommended Action The switch is in an inconsistent state and can be corrected only by a reboot or power cycle. Before rebooting the chassis, record the firmware version on the switch or control processor (CP) and run the haDump command. If this is a dual-CP switch, gather the output from the CP in which this log message appeared. SYSC-1004 Message Daemon restart successful. Message Type LOG Severity INFO Probable Cause Indicates that a terminated daemon is restarted by the system automatically. Recommended Action Execute the supportSave command to gather troubleshooting data. No further action is required. 852 Fabric OS Message Reference 53-1002749-01