Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 173

AUTH-1026 5 AUTH-1026 Message Failed to during negotiation phase: port . Message Type LOG Severity WARNING Probable Cause Indicates that the authentication failed to get device or Host Bus Adapter (HBA) information due to an internal failure. Usually this problem is transient. If the authentication failed, retry the login. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1027 Message Failed to select during : value port . Message Type LOG Severity ERROR Probable Cause Indicates that the authentication process failed to select an authentication value (DH Group, hash value, or protocol type) from a receiving payload for a particular authentication phase. This indicates that the local switch does not support the specified authentication value. Recommended Action Check the authentication configuration and reset the supported value if needed using the authUtil command. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AUTH-1028 Message Failed to allocate for : port . Message Type LOG Severity ERROR Probable Cause Indicates that the authentication process failed because the system is low on memory. Usually this problem is transient. The authentication may fail. The Data type is the payload or structure that failed to get memory. The Operation phase specifies which operation of a particular authentication phase failed. Fabric OS Message Reference 151 53-1002749-01