Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 856

5 SULB-1017 Recommended Action Run the firmwareDownloadStatus command for more information. Refer to the Fabric OS Troubleshooting Guide for troubleshooting information. SULB-1017 Message Firmwaredownload failed in slot . Message Type AUDIT | LOG Class FIRMWARE Severity ERROR Probable Cause Indicates that the firmwareDownload command failed on the specified blade. The error may be caused by the inconsistent application processor (AP) blade firmware stored on the active CP. It may also be caused by an internal Ethernet issue or by a persistent storage hardware failure. Recommended Action Run the slotShow command. If the blade is in the FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmware download. If the blade is stuck in the LOADING state, remove and re-insert the blade to trigger another firmware download. If the problem persists, contact your switch service provider. SULB-1018 Message Firmwaredownload timed out in slot . Message Type AUDIT | LOG Class FIRMWARE Severity ERROR Probable Cause Indicates that there may be error caused by the blade initialization issue after the new firmware is downloaded and the blade is rebooted. The error may also be caused by an internal Ethernet issue or by a persistent storage hardware failure. Recommended Action Run the slotShow command. If the blade is in the FAULTY state, run the slotPowerOff and slotPowerOn commands to trigger another firmware download to the blade. If the blade is stuck in the LOADING state, remove and re-insert the blade to trigger another firmware download. If the problem persists, contact your switch service provider. 834 Fabric OS Message Reference 53-1002749-01