Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 458

5 FSSM-1002 FSSM Messages FSSM-1002 Message HA State is in sync. Message Type LOG Severity INFO Probable Cause Indicates that the high availability (HA) state of the active control processor (CP) is in synchronization with the HA state of the standby CP. If the standby CP is healthy, the failover will be nondisruptive. Recommended Action No action is required. FSSM-1003 Message HA State out of sync. Message Type LOG Severity WARNING Probable Cause Indicates that the high availability (HA) state of the active control processor (CP) is out of synchronization with the HA state of the standby CP. If the active CP failover occurs when the HA state is out of synchronization, the failover is disruptive. Recommended Action If this message was logged as a result of a user-initiated action (such as running the reboot command), no action is required. Otherwise, execute the haSyncStart command on the active CP to resynchronize the HA state. If the HA state does not synchronize, execute the haDump command to diagnose the problem. If the problem persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. FSSM-1004 Message Incompatible software version in HA synchronization. Message Type LOG Severity CRITICAL Probable Cause Indicates that the active control processor (CP) and the standby CP in a dual CP system are running firmware that is incompatible with each other. If the active CP fails, the failover will be disruptive. In a switch system, this message is logged when a firmware upgrade or downgrade was invoked. The new firmware version is not compatible with the current running version. This causes a disruptive firmware upgrade or downgrade. 436 Fabric OS Message Reference 53-1002749-01