Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 157

AG-1042 5 AG-1042 Message Sending ELS_PORT_OPEN failed on N_Port . Message Type LOG Severity WARNING Probable Cause Indicates there was a failure sending an ELS_PORT_OPEN request from the Access Gateway to the fabric switch. Recommended Action Check the configuration of the fabric switch connected to the Access Gateway. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. AG-1043 Message Authentication cannot be negotiated with the connected switch/HBA and therefore disabling the Port . Message Type LOG Severity WARNING Probable Cause Indicates that authentication has failed on the specified port. A possible reason could be that the edge switch connected to Access Gateway is using firmware earlier than Fabric OS v7.1.0. Recommended Action Check the authentication configuration of the edge switch using the authutil --show command. AG-1044 Message Port has been disabled because switch requires authentication when device authentication policy is set to ON. Message Type LOG Severity WARNING Probable Cause Indicates a device that does not support authentication has tried to log in to the switch when the device authentication policy is in ON status on the switch. Recommended Action Enable the authentication on the device or set the device authentication status to PASSIVE/OFF on the switch if it is not mandatory. Use the authUtil command to change the device authentication policy. Fabric OS Message Reference 135 53-1002749-01