Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 568

5 HAMK-1001 HAMK Messages HAMK-1001 Message Warm Recovery Failed. Message Type LOG | FFDC Severity CRITICAL Probable Cause Indicates that the switch failed during the warm recovery. Recommended Action This event triggers the switch restart automatically and attempts a cold recovery. Execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. HAMK-1002 Message Heartbeat down. Message Type LOG Severity INFO Probable Cause Indicates that the active control processor (CP) blade determined that the standby CP blade is down. This can be a result of a user-initiated action such as firmware download, the standby CP blade being reset or removed, or an error in the standby CP blade. Recommended Action Monitor the standby CP blade for a few minutes. If this message is due to a standby CP restart, the HAMK-1003 message will display after the standby CP is restarted. If the standby CP does not connect to the active CP after 10 minutes, restart the standby CP blade by ejecting the blade and reseating it. HAMK-1003 Message Heartbeat up. Message Type LOG Severity INFO Probable Cause Indicates that the active control processor (CP) blade detected the standby CP blade. This means that the standby CP blade is available to take over in case a failure happens in the active CP blade. Typically, this message is displayed when the standby CP blade restarts. Recommended Action No action is required. 546 Fabric OS Message Reference 53-1002749-01