Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 854

5 SULB-1009 The following descriptions explain the causes of some common error messages: • 0x15 - "Failed to download RPM package." If this error occurs immediately after firmware download is started, the firmware on the switch may be two releases older than the requested firmware. The firmware download operation supports firmware upgrades within two feature releases (a feature release is indicated by a major number and a minor number; for example, X.Y). In this case, you will need to upgrade to an intermediate version before downloading the desired version. If this error occurs in the middle of a firmware download, the firmware in the file server may be corrupted or there may be a temporary network issue. In this case, retry the firmwareDownload command. If the problem persists, contact your system administrator. • 0x18 - "Error in getting lock device for firmware download". This error can be due to another firmware download is already in progress. Run the firmwareDownloadStatus command to verify that this is the case. Wait for the current session to finish before proceeding. • 0x23 - "Firmware download timed out." This error may occur because the firmwareDownloadStatus command has not completed within the predefined timeout period. It is most often caused by network issues. If the problem persists, contact your system administrator. • 0x24 - "Out of disk space." This error may occur because some core dump files have not been removed from the filesystem and are using up disk space. Remove these core dump files by using the supportSave command before proceeding. • 0x29 - "The pre-install script failed." This error may be caused by an unsupported blade type. Remove or power off the unsupported blades before proceeding. • 0x2e - "Invalid RPM package." This error may be caused by an inconsistent firmware image loaded on the file server. It may also be caused by temporary networking issues. Reload the firmware packages on the file server and then retry the firmwareDownload command. If the problem persists, contact your system administrator. The following table lists the firmwareDownload state names and code values. They indicate where in the firmwareDownload process the error occurred. TABLE 9 Upgrade state and code value Upgrade state Code SUS_PEER_CHECK_SANITY SUS_PEER_FWDL_BEGIN SUS_SBY_FWDL_BEGIN SUS_PEER_REBOOT SUS_SBY_REBOOT SUS_SBY_FABOS_OK SUS_PEER_FS_CHECK SUS_SELF_FAILOVER SUS_SBY_FWDL1_BEGIN SUS_SELF_FWDL_BEGIN SUS_SELF_COMMIT SUS_SBY_FWC_BEGIN SUS_SBY_COMMIT SUS_SBY_FS_CHECK 0x21 0x22 0x23 0x24 0x25 0x26 0x27 0x28 0x29 0x2a 0x2b 0x2c 0x2d 0x2e 832 Fabric OS Message Reference 53-1002749-01