Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 330

5 FABR-1012 FABR-1012 Message : no such type, . Message Type LOG Severity WARNING Probable Cause Indicates that the fabric is not in the appropriate state for the specified process. This message is rare and usually indicates a problem with the Fabric OS. Recommended Action The fabric daemon will take proper action to recover from the error. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. FABR-1013 Message No Memory: pid= file= line=. Message Type FFDC | LOG Severity CRITICAL Probable Cause Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is rare and usually indicates a problem with the Fabric OS. Recommended Action The system will recover by failing over to the standby CP. If the message persists, run the supportFtp command (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. FABR-1014 Message Port Disabled: Insistent Domain ID could not be obtained. Principal Assigned Domain ID = . Message Type LOG Severity ERROR Probable Cause Indicates that the specified port received a request domain ID (RDI) accept message containing a principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). Fibre connectivity (FICON) mode requires an insistent domain ID. If an RDI response has a different domain ID, then the port is disabled. Recommended Action Run the configShow command to view the fabric.ididmode. A 0 means the IDID mode is disabled; a 1 means it is enabled. Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web Tools on the Switch Admin > Configure window. 308 Fabric OS Message Reference 53-1002749-01