Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 311

EM-1047 5 Recommended Action If the blade ID listed is incorrect, the field-replaceable unit (FRU) header for the blade is corrupted and the blade must be replaced. If the error is due to the platform, the blade ID listed is not supported for that platform (CP) type. Remove the blade from the chassis. If the error is due to the backplane, the CP type (CP256) is not supported on that chassis (backplane revision D2). Remove the blade from the chassis. If the error is due to the switch configuration, the logical switch configuration of the blade is incorrect. Execute the lscfg command to correct the switch or port configuration for the ports on the blade. EM-1047 Message CP in slot not faulty, CP ERROR deasserted. Message Type LOG Severity INFO Probable Cause Indicates that the control processor (CP) is no longer faulted. This message usually follows the EM-1033 message. The new standby CP is in the process of restarting and has turned off the CP_ERR signal. Recommended Action No action is required. EM-1048 Message I2C access recovered: state . Message Type LOG Severity INFO Probable Cause Indicates that the Inter-Integrated Circuit (I2C) bus problems have been resolved and I2C access to the field-replaceable unit (FRU) has become available again. Recommended Action No action is required. The EM-1048 message is displayed when the EM-1029 error is resolved. EM-1049 Message FRU insertion detected. Message Type LOG Severity INFO Probable Cause Indicates that a field-replaceable unit (FRU) of the type and location specified by the FRU ID value was detected as having been inserted into the chassis. Fabric OS Message Reference 289 53-1002749-01