Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 198

5 BL-1037 BL-1037 Message Faulting chip in slot = , miniS = ,port = due to BE/BI port fault. Message Type LOG Severity CRITICAL Probable Cause Indicates that all ports on the chip have been disabled due to a fault on the chip. Recommended Action Make sure that the blade is seated correctly. If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test (POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware problems. Additional blade fault messages precede and follow this error, providing more information. Refer to other error messages for recommended action. If the message persists, replace the blade. BL-1038 Message Inconsistent FPGA image version detected, please reboot the switch for recovery. Message Type LOG Severity CRITICAL Probable Cause Indicates that the field-programmable gate array (FPGA) image version is incompatible with the software version. Recommended Action Reboot the switch. If the message persists, replace the switch. BL-1039 Message Inconsistent FPGA image version detected, faulting the blade in slot . Message Type LOG Severity CRITICAL Probable Cause Indicates that the field-programmable gate array (FPGA) image version is incompatible with the software version. Recommended Action Power cycle the blade using the slotPowerOff and slotPowerOn commands. If the message persists, replace the blade. 176 Fabric OS Message Reference 53-1002749-01