Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 232

5 CDR-1010 CDR-1010 Message S,C: Internal monitoring of faults has identified suspect hardware, blade may need to be reset or replaced: fault1:0x, fault2:0x thresh2:0x. Message Type LOG Severity CRITICAL Probable Cause Indicates that above-normal errors observed in hardware that may or may not impact the data traffic. Recommended Action When this error is observed persistently, power cycle the specified blade using the slotPowerOff and slotPowerOn commands. If the problem persists, replace the blade. CDR-1011 Message S,P(): Link Timeout on internal port ftx= tov= (>) vc_no= crd(s)lost= complete_loss:. Message Type LOG Severity WARNING Probable Cause Indicates that one or more credits have been lost on a back-end port, and there is no traffic on that port for two seconds. Recommended Action Turn on the back-end credit recovery to reset the link and recover the lost credits. If credit recovery has already been turned on, the link will be reset to recover the credits and no action is required. CDR-1012 Message S,P(): Port Fault: Hard () fault1= fault2= (0x 0x 0x). Message Type LOG Severity WARNING Probable Cause Indicates that the specified port has failed. Port initialization will be retried. Recommended Action Replace the SFP transceiver and the cable and then re-enable the port. 210 Fabric OS Message Reference 53-1002749-01