Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 849

SULB-1007 5 SULB-1007 Message Standby CP reboots. Message Type LOG Severity INFO Probable Cause Indicates that the standby control processor (CP) is rebooting with new firmware. Recommended Action No action is required. The firmwareDownload command is progressing as expected. Run the firmwareDownloadStatus command for more information. SULB-1008 Message Standby CP booted successfully with new firmware. Message Type LOG Severity INFO Probable Cause Indicates that the standby control processor (CP) has rebooted successfully. Recommended Action No action is required. The firmwareDownload command is progressing as expected. Run the firmwareDownloadStatus command for more information. SULB-1009 Message Firmwaredownload command failed. Status: 0x, error: 0x. Message Type AUDIT | LOG Class FIRMWARE Severity INFO Probable Cause Indicates that the firmwareDownload command failed. The additional status code and error code values provide debugging information. The following table lists firmwareDownload status messages and status codes. Some of them will not be displayed in this RASLog message and are listed for completeness. TABLE 7 Status messages and status codes Status message Status code "Firmware download sanity check failed." "Sanity check failed because system is non-redundant." "Sanity check failed because firmware download is already in progress." "Sanity check failed because Fabric OS is disabled on active CP." 0x30 0x31 0x32 0x33 Fabric OS Message Reference 827 53-1002749-01