Dell Brocade 6520 Message Reference Supporting Fabric OS v7.1.0 - Page 442

5 FICU-1007 Recommended Action Check if the FICON channel corresponding to the PID in the message is functioning correctly. FICU-1007 Message : Failed to allocate memory while performing . Message Type LOG Severity WARNING Probable Cause Indicates that memory resources are low. This may be a transient problem. Recommended Action Check the memory usage on the switch using the memShow command. If the message persists, execute the supportFtp command (as needed) to set up automatic FTP transfers; then execute the supportSave command and contact your switch service provider. FICU-1008 Message FMS mode has been enabled. Port(s): have been disabled due to port address conflict. Message Type LOG Severity INFO Probable Cause Indicates that the specified ports were disabled when the FICON Management Server (FMS) mode was enabled. This is due to a port address conflict or the port address being reserved for the CUP management port. Recommended Action No action is required. FICU-1009 Message FMS Mode enable failed due to insufficient frame filtering resources on some ports. Message Type LOG Severity WARNING Probable Cause Indicates that the frame filtering resources required to enable FICON Management Server mode (fmsMode) were not available on some of the ports. Recommended Action Execute the haFailover command on the switch if it has redundant control processors (CPs) or reboot the switch. 420 Fabric OS Message Reference 53-1002749-01