D-Link DGS-3620-52T CLI Guide - Page 1005

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 95 Static Multicast Route Commands create ipmroute rpf_address [ | null] delete ipmroute [ | all] show ipmroute {} 95-1 create ipmroute Description This command is used to create an IP multicast static route configuration entry. Normally, when an IP multicast packet is received, the source IP address of the packet is used to do the RPF check. When the RPF network is configured for a network, if the source IP address of the received IP multicast packet matches this network, the RPF network will be used to do RPF check. The IP multicast static route can be assigned to the RPF check path to the Switch in order to control the IP multicast routing path. It needs to work with a multicast route protocol such as PIM. It takes higher priority than unicast route information and multicast route information when the RPF checking is done. The RPF check rule will first check whether it matches an entry in the IP multicast static route table before continuing. Format create ipmroute rpf_address [ | null] Parameters - Specifies the source IP address of the received IP multicast packet matches this network, the RPF address is used to do RPF check. rpf_address - Specifies the IP address, it means that if the source IP address of the received IP multicast packet match the network_address, rpf_address will be used to check whether packet receive from legal interface. - Enter the RPF IP address used here. null - Specifies that if it is set to null, it means that if the source IP address in the received IP multicast packet match network_address, RPF check will always fail. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To create ip multicast static route entry: 1000