D-Link DGS-3620-52T CLI Guide - Page 117
<value 0-65535>
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide mask - Specifies the destination IP address used here. - Enter the destination network mask here. dscp - (Optional) Specifies the value of DSCP. The DSCP value ranges from 0 to 63. - Enter the DSCP value used here. This value must be between 0 and 63. icmp - (Optional) Specifies that the following parameters configured will apply to the ICMP configuration. type - Specifies that the rule will apply to the ICMP type traffic value. - Enter the ICMP traffic type value here. This value must be between 0 and 255. code - Specifies that the rule will apply to the ICMP code traffic value. - Enter the ICMP code traffic value here. This value must be between 0 and 255. igmp - (Optional) Specifies that the following parameters configured will apply to the IGMP configuration. type - Specifies that the rule will apply to the IGMP type traffic value. - Enter the IGMP type traffic value here. This value must be between 0 and 255. tcp - (Optional) Specifies that the following parameters configured will apply to the TCP configuration. src_port - Specifies that the rule will apply to a range of TCP source ports. - Enter the source port value here. This value must be between 0 and 65535. mask - Specifies the TCP source port mask here. - Enter the TCP source port mask value here. dst_port - Specifies that the rule will apply to a range of TCP destination ports. - Enter the destination port value here. This value must be between 0 and 65535. mask - Specifies the TCP destination port mask here. - Enter the TCP destination port mask value here. flag - (Optional) Specifies the TCP flag fields. all - Specifies that the TCP flag field will be set to 'all'. urg - Specifies that the TCP flag field will be set to 'urg'. ack - Specifies that the TCP flag field will be set to 'ack'. psh - Specifies that the TCP flag field will be set to 'psh'. rst - Specifies that the TCP flag field will be set to 'rst'. syn - Specifies that the TCP flag field will be set to 'syn'. fin - Specifies that the TCP flag field will be set to 'fin'. udp - (Optional) Specifies that the following parameters configured will apply to the UDP configuration. src_port - Specifies the UDP source port range. - Enter the UDP source port range value here. mask - Specifies the UDP source port mask here. - Enter the UDP source port mask value here. dst_port - Specifies the UDP destination port range. - Enter the UDP destination port range value here. mask - Specifies the UDP destination port mask here. - Enter the UDP destination port mask value here. protocol_id - (Optional) Specifies that the rule will apply to the value of IP protocol ID traffic. - Enter the protocol ID used here. This value must be between 0 and 255. user_define - (Optional) Specifies that the rule will apply to the IP protocol ID and that the mask options behind the IP header, which has a length of 20 bytes. - Enter the user-defined mask value here. mask - Specifies the user-defined mask here. - Enter the user-defined mask value here. ipv6 - Specifies the rule applies to IPv6 fields. class - (Optional) Specifies the value of IPv6 class. - Enter the IPv6 class value here. This value must be between 0 and 255. source_ipv6 - (Optional) Specifies the value of IPv6 source address. - Enter the source IPv6 source address here. mask - Specifies the IPv6 source address mask here. 112