D-Link DGS-3620-52T CLI Guide - Page 637
show loopback ipif
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 637 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Format config loopback ipif [{ipaddress | state [enable | disable]}(1)] Parameters - Enter the IP interface name used for this configuration here. This name can be up to 12 characters long. ipaddress - (Optional) Specifies the IPv4 network address of the loopback interface. - Enter the IPv4 network address of the loopback interface here. It specifies a host address and length of network mask. state - (Optional) Specifies the state of the loopback interface. enable - Specifies that the loopback interface state will be enabled. disable - Specifies that the loopback interface state will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the loopback interface named loopback1 with subnet address 10.0.0.1/8: DGS-3620-28SC:admin# config loopback ipif loopback1 ipaddress 10.0.0.1/8 Command: config loopback ipif loopback1 ipaddress 10.0.0.1/8 Success. DGS-3620-28SC:admin# 55-3 show loopback ipif Description This command is used to display the information of the loopback interface. Format show loopback ipif {} Parameters - (Optional) Enter the IP interface name used for this configuration here. This name can be up to 12 characters long. Restrictions None. 632