D-Link DGS-3620-52T CLI Guide - Page 394
Distance Vector, Multicast Routing, Protocol DVMRP, Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 394 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 26 Distance Vector Multicast Routing Protocol (DVMRP) Commands config dvmrp [ipif | all] {metric | probe | neighbor_timeout | state [enable | disable]}(1) enable dvmrp disable dvmrp show dvmrp {ipif } show dvmrp neighbor {ipif | ipaddress } show dvmrp nexthop {ipaddress | ipif } show dvmrp routing_table {ipaddress } 26-1 config dvmrp Description This command is used to configure DVMRP configurations. Format config dvmrp [ipif | all] {metric | probe | neighbor_timeout | state [enable | disable]}(1) Parameters ipif - Specifies the IP interface name used. - Enter the IP interface name used here. This name can be up to 12 characters long. all - Specifies that all the IP interfaces will be used. metric - (Optional) Allows the assignment of a DVMRP route cost to the above IP interface. A DVMRP route cost is a relative number that represents the real cost of using this route in the construction of a multicast delivery tree. It is similar to, but not defined as, the hop count in RIP. - Enter the metric value used here. This value must be between 1 and 31. The default value is 1. probe - (Optional) Specifies the time in seconds between the DVMRP Probe message transmissions. - Enter the probe value used here. This value must be between 1 and 65535 seconds. The default value is 10 seconds. neighbor_timeout - (Optional) Specifies the time period for DVMRP will hold Neithbor Router reports before issuing poison route messages. - Enter the neighbor timeout value used here. This value must be between 1 and 65535 seconds. The default value is 35 seconds. state - (Optional) Specifies the DVMRP state of the IP interface. enable - Specifies that DVMRP of the specified IP interface will be enabled. 389