D-Link DGS-3620-52T CLI Guide - Page 997

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 93 Stacking Commands config stacking_mode [disable | enable] config stacking force_master_role state [enable | disable] show stacking_mode show stack_information show stack_device config box_id current_box_id new_box_id [auto | ] config box_priority current_box_id priority 93-1 config stacking_mode Description This command configures the state of stacking function. By default stacking mode is disabled. Administrators need to specifically configure the stacking mode to make the switch stackable. Stacking mode can be changed under standalone mode only! Format config stacking_mode [disable | enable] Parameters enable - Specifies that the Switch's stacking capability will be enabled. disable - Specifies that the Switch's stacking capability will be disabled. Restrictions Only Administrator-level users can issue this command. Example To enable stacking mode: DGS-3620-28SC:admin# config stacking_mode enable Command: config stacking_mode enable Change Box stacking_mode may cause devices work restart, still continue?(y/n) y Please wait, the switch is rebooting... 93-2 config stacking force_master_role state Description This command is used to configure stacking force master role state. If state is enabled, when device is in election state, it still uses old priority setting and MAC to compare device priority. After stacking is stable, master's priority will become zero. If stacking topology change again, Master will use priority zero and MAC address to determine who new primary master is. 992