D-Link DGS-3620-52T CLI Guide - Page 1063

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide priority - (Optional) Specifies the priority to be used for the Virtual Router Master election process - Enter the priority value used here. This value must be between 1 and 254. advertisement_interval - (Optional) Specifies the time interval used between sending advertisement messages. - Enter the advertisement interval value here. This value must be between 1 and 255 seconds. preempt - (Optional) Controls whether a higher priority virtual router will preempt a lower priority master. The preempt setting must be consistent with all the routers participating within the same VRRP group. Default is settings is true. true - Specifies that if the backup router's priority is set higher than the masters priority, it will become the master instead of the current one. false - Specifies that if the backup router's priority is higher than the masters priority, it will not become the master until the master failed. critical_ip - (Optional) Specifies an IP address that will provide the most direct route to the Internet or other critical network connections from this virtual router. This IP address must be a real IP address of a real device on the network. If the connection from the virtual router to this IP address fails, the virtual router will automatically be disabled. A new Master will be elected from the backup routers participating in the VRRP group. Different critical IP addresses may be assigned to different routers participating in the VRRP group and can therefore define multiple routes to the Internet or other critical network connections. - Enter the critical interface's IP address used here. critical_ip_state - (Optional) Specifies the state of checking the status (active or inactive) of a critical IP address. enable - Specifies that the critical IP state checking will be enabled. disable - Specifies that the critical IP state checking will be disabled. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To create a VRRP entry: DGS-3620-28SC:admin# create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state enable Command: create vrrp vrid 1 ipif System ipaddress 10.90.90.91 state enable Success. DGS-3620-28SC:admin# 104-4 config vrrp vrid Description This command is used to configure the virtual router settings by VRID. Format config vrrp vrid ipif {state [enable | disable] | priority | ipaddress | advertisement_interval | preempt [true | false] | critical_ip | critical_ip_state [enable | disable]} 1058