D-Link DGS-3620-52T CLI Guide - Page 321
debug bgp access_list
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 321 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin# debug bgp router_map enable Command: debug bgp router_map enable Success. DGS-3620-28SC:admin# config bgp neighbor map 15.0.0.1 route_map in add map1 Command: config bgp neighbor map 15.0.0.1 route_map in add map1 Success. DGS-3620-28SC:admin# Output Examples: After configure BGP to enable route map debug flag, it may print following information when route map applied. route_map:,apply bgp neighbor: MATCH. route_map:,apply bgp static route: Not MATCH. 20-54 debug bgp access_list Description This command is used for setting access_list debugging flags to disable or enable. If this flag is enable, access list permit or deny in BGP module will be displayed Format debug bgp access_list [enable | disable] Parameters enable - Enable the access_list debug function. disable - Disable the access_list debug function. Restrictions Only Administrator-level users can issue this command. (EI Mode Only Command) Example Configure access list debug flags' state to enable: DGS-3620-28SC:admin# debug bgp access_list enable Command: debug bgp access_list enable Success. DGS-3620-28SC:admin# Output Examples: After configure BGP to enable access list debug flag, it may print following information when access list applied. 316