D-Link DGS-3620-52T CLI Guide - Page 781

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Total Entries: 0 DGS-3620-28SC:admin# show ospfv3 all Command: show ospfv3 all Interface Name: System FE80::201:2FF:FE03:400 (Link Up) Network Medium Type: BROADCAST Area ID: 0.0.0.0 Priority: 1 DR ID: None Hello Interval: 10 Transmit Delay: 1 Passive Mode: Disabled Link Local Address: Metric: 10 Administrative State: Disabled DR State: DOWN Backup DR ID: None Dead Interval: 40 Retransmit Time: 5 Instance ID: 0 Total Entries: 1 DGS-3620-28SC:admin# show ospfv3 ipif System Command: show ospfv3 ipif System Interface Name: System FE80::201:2FF:FE03:400 (Link Up) Network Medium Type: BROADCAST Area ID: 0.0.0.0 Priority: 1 DR ID: None Hello Interval: 10 Transmit Delay: 1 Passive Mode: Disabled Link Local Address: Metric: 10 Administrative State: Disabled DR State: DOWN Backup DR ID: None Dead Interval: 40 Retransmit Time: 5 Instance ID: 0 Total Entries: 1 DGS-3620-28SC:admin# 70-4 config ospfv3 router_id Description This command is used to configure the OSPFv3 router ID. Format config ospfv3 router_id Parameters - Specifies that the user may enter a 32-bit number in the form of an IPv4 address that uniquely identifies the router in the OSPFv3 domain. Setting it to be 0.0.0.0 means autoselected. The Switch will select the largest IPv4 address among the IP interfaces to be the router ID. The default for the OSPFv3 router ID is 0.0.0.0 (auto-selected). Only by executing this command, can the OSPFv3 router ID be changed. 776