D-Link DGS-3620-52T CLI Guide - Page 1014
Super VLAN and, Sub-VLAN Commands
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1014 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Chapter 97 Super VLAN and Sub-VLAN Commands create super_vlan [ | vlanid ] {sub_vlan } config super_vlan [ | vlanid ] [add | delete] sub_vlan delete super_vlan [ | vlanid ] config sub_vlan [ | vlanid ] [add | delete] ip_range to show super_vlan {[ | vlanid ]} show sub_vlan {[ | vlanid ]} 97-1 create super_vlan Description This command is used to create a super VLAN. The specified VLAN must be an 802.1Q VLAN. If the specified VLAN does not exist, the operation will fail. Note: A Layer 3 Routing Protocol, like VRRP, the Multicast Protocol, and the IPv6 Protocol cannot run on a super VLAN interface. Super VLANs are used to aggregate multiple sub-VLANs in the same IP subnet. A sub-VLAN is a Layer 2, separated broadcast domain. The super VLAN cannot have any physical member ports and hosts that resides within any sub-VLANs. Once an IP interface is bound to a super VLAN, the proxy ARP will be enabled automatically on the specified interface for the communication between its sub-VLANs. If an IP interface is bound to a super VLAN, it cannot be bound to any other VLANs. A super VLAN cannot be a sub-VLAN of other super VLANs. Format create super_vlan [ | vlanid ] {sub_vlan } Parameters - Enter the VLAN name used here. This name can be up to 32 characters long. vlanid - Specifies the VLAN ID used. - Enter the VLAN ID used here. This value must be between 1 and 4094. sub_vlan - (Optional) Specifies the sub-VLANs of the super VLAN. By default, a new created super VLAN has no sub-VLANs configured. - Enter the VLAN ID of the sub-VLAN used here. This value must be between 1 and 4094. Restrictions Only Administrator, Operator and Power-User level users can issue this command. 1009